I recently had an electrician in my house replacing all my outlet from 2 pronged outlets to 3 pronged grounded outlets. Part of the series: Ceiling Fans & Home Maintenance. The key is using metal-to-metal connection. The following is a list of mistakes to Electrical Outlets. Should you ever need to ground electrical outlets that have no grounding wire, don't worry—it is possible. This was a non-GFCI outlet … I know to wrap the ground from the outlet to the ground screw , but what about the fixture's two copper wires? Sent from my iPhone using ET Forum Plastic pigtail and ground the device. Protect wiring from nails and screws. Or wrap it around the screw and tighten the screw. Wrap the bare ground wire you attached to the electrical box around the green ground screw attached to the strap. Glue is an insulator, so if you glue the wire back on, it won’t act as a ground wire anymore. ground wires.. Not sure what there's two and how do i connect these? member to any wire to keep drywall screws and long trim nails from puncturing the insulation and causing a short. If you can’t attach the wire back the way it was, wrap it around any available screw in the fixture that touches bare metal. Often the grounding wire is wrapped around the cable as it enters the box. I noticed that he never wrapped the outlets with electrical tape, nor did he really tighten them into the box. Thanks in advance. So I have an outlet with a black, a white and a ground (copper). Bought a new outdoor fixture and it has a black, a white and TWO(?) Get needle-nose pliers and twist the very tip of the wire to make a hook. Ground wires are spliced together and attached with a pigtail to the box and receptacle. Wire connectors, either crimp or wire nut types are not required to be listed for bonding and grounding when used to terminate grounding and bonding conductors. The grounding wire nut shown has a hole in its top that makes installing a pigtail easier. Metal boxes I just bond the box. You loosen the screw, separate the plate from the switch body (easiest to let gravity do the work; turn it plate-down and shake), insert the wire stripped to the proper length, then tighten down the side screw. But it states " continuity shall not be lost while removing the device" so by wrapping is okay and hit device or not, by using self grounding device. Is it necessary to wrap an electrical tape around an electrical receptacle (plug) after the tightening the wire screws? Other methods also work well if installed correctly; one such method is a grounding clip that clamps the ground wire to the box. See 250.8(1). Use this hook to go around the ground screw and then tighten the screw. 1. When I pulled one of the outlets out of the box, I noticed that 1) there was no ground wire anywhere, 2) two white wires were under the same screw and one single black wire on the other side. In this case, you should pigtail all of the device grounds together and have one lead from the pigtail ground to the metal device fixture box and another lead used as a ground … How to Install a Ceiling Light Without a Place for the Ground Wire. that make electrical work code-compliant and safe. I was trying to replace a few electrical outlets around the house with new tamper-resistant ones. It works a lot like side-wiring, except you don't have to curl the wire around the screw. The wiring method of wrapping the wire around the screw is not stated. Wrap the bare or green wire from the ceiling light around the same screw. Secure the ground wire. If you’re ready to go to work, keep reading.